Wez_
CB750 Addict
So I got the engine removed from the frame successfully using the clymers manual...
so far so good
Measured valve clearances....needed a metric feeler gauge....
I used the book and the notch cut out of the end of the exhaust camshaft...I aligned it in each position relative to the bearing and block and each lobe was on the base circle that the manual was telling me to measure at. I ran through again just to make double check the numbers. I will make damn sure to practice this measurement if this is what keeps the engines happy...
so far so good
Measured valve clearances....needed a metric feeler gauge....
I used the book and the notch cut out of the end of the exhaust camshaft...I aligned it in each position relative to the bearing and block and each lobe was on the base circle that the manual was telling me to measure at. I ran through again just to make double check the numbers. I will make damn sure to practice this measurement if this is what keeps the engines happy...