loxley007

Nice one. I’m 5 months in to my first ever build. A 1979 CB750. Totally new to anything mechanical but loving it. Just starting my...

Looks great. How does it feel to get it out on the road after all that time?

Fantastic, thanks for the advice.

Hi all, I need to pull the sleeves from my 1979 CB750 engine (I need to swap out damaged ones for non damaged ones). My question is...

Cheers all

I am Groot.

Hi all, I’m working on removing baked on gasket and want to check whether I need 100% removed or whether a tiny bit left is ok? Any...

Hi all, I’m UK based and just about to start rebuild my CB750 engine following a full bottom end and top end strip down. My question is...

I’m in it to win it.

Answering my own post. Invested in an air compressor for drying. Used serious amounts of degreaser, hot water, nylon brush and kitchen...

Thanks, I ended up buying one of the rotor pullers. That did the job although I really had to hit it hard before it decided to pop off...

Hi all, I’m looking for advice on how to clean the bottom end? I’ve split the case and I know I’ve got a job on my hands as I had to...

Sorted, all removed. Now just a very stubborn rotor to go before being able to split the case.

Thanks, it’s the part attached to the part that is riveted on. I think mallet is the way to go!!

Great progress!

I would appreciate some advice on how to get a few items off as I do a bottom end tear down on my 79. I’m fairly well advanced in the...

Happy New Year everyone. I’m in!!

Thanks both, it looks like they use the same pistons which suggests they use the same block and header so that’s a good thing. Thanks...

Hi all, can anyone tell me whether a 1980 CB750KZ DOHC (UK version) RC01 engine is the same as the 750K (North American version) RC01...

Some progress has been made with the valves - they are now all out. I ended up carefully tapping them out and using a bunch of...

Congratulations

Cheers, that a job for the weekend!!

Thanks all. I’m not that worried about keeping the original parts more about getting the engine running for as low a cost as possible...