neck bearings for front end swaps

[RattyRatbikes]

Does anyone remember the website that had that 50 zillion mile long list of just about every tapered neck bearing used by motorcycles? If memory serves the site had a lot of blue on it.

I snagged a great Harley girder front end at a swap meet. Was going to have a stem made but the hand work on the stem mount is too beautiful for me to drill cut and weld.
I'm looking for the bearings chart so I can try to find the year that Harley had the same outer race diameter as the cb750 but still used the 1 inch stem.

OORR if anyone has a link to a kit for bearings that use the cb750 outer Dia. and 1 inch inner Dia.

 

[Old_Crow]

Years ago I used a Yamaha dirt bike front wheel on an aftermarket Harley girder front end on a Triumph chopper I was building. I took the diameter of the axle and the diameter of the hole in the wheel hub to a NAPA store and they looked up a bearing set that was close. I ended up having to open up the hole in the hub a little bit using a Dremel tool, but it worked.