Hi there, I am new here and have just bought my first CB750. It has been stood for 10 years or so and had the carbs rebuilt just before i bought it and a full service. Was running pretty rough so i pulled the carbs to clean and blow them through. Now they are back on the bike and I'm struggling to get the float bowls to fill with fuel. I connect the fuel line an open the fuel tap and no.1 carb seems to be getting fuel but 2,3 and 4 have no fuel out of the drain screws... I have a clymer manual which shows a accelerator pump on carb 2 but mine don't seem to have this... is this correct?
Where should the vacuum line from carb 2 go? mine was connected but blanked off.
The fuel balance pipe has a T piece in it but nothing connected to it. is this correct?
What is the correct method to fill the carbs up with fuel after they have been off or should they just gravity feed?
Where should the vacuum line from carb 2 go? mine was connected but blanked off.
The fuel balance pipe has a T piece in it but nothing connected to it. is this correct?
What is the correct method to fill the carbs up with fuel after they have been off or should they just gravity feed?