Davidson750

You would probably need to fabricate/modify something(cut,weld)...or find a set off another bike and drop it. Be careful going around...

How long did you run that bike with the new plugs in it? One is slightly fouled the other doesn't look too bad a little lean but that's...

OK.

Awesome

Gentle taps...its probably got some sort of rtv holding it.

Tap with rubber mallet... if you're talking about the gear on the outer housing it is riveted on.

1972.

Deleted

That's the pickup I did on a rebuild a few years ago cb750f..and still managed to circulate oil...

Looks like ring material...what did the oil filter itself look like? It's an overhead cam motor so if any metal that started at the top...

If you look at the uni air filter it has no structure, or frame it is just foam.. on a motocross bike we call it a cage or a frame and...

The only problem with the "UNI" is that you will still need your cage for it.. I recommend HI-FLO-FILTRO HFA1706.. it will give you all...

Let me understand... you had head work done.. then you ran the motor, when did you notice the screen intake being clogged?..after or...

No it's not needed.. add some zinc

I have kehein vb42-43

You should have no issues, a ratchet wrench will come in handy, you probably noticing the oil on the sides of the valve cover that's...

I brazed small "T-HANDLES " to mine...it has been a problem on more than one bike,.. I have found it almost the only way to adjust the...

.005 intake and exhaust.. Do not turn over without shim installed,you will need shims and valve tool.

What about bore diameter... One is approximately 65mm, the other is 62mm