nsxguy7
CB750 Member
Hello all. I've searched for the answer to my problem. Please help if you know the answer.
I replaced my worn out front sprocket with a new one. I replaced the retaining washer as well.
I have everything tightened down, but I can still wiggle the sprocket back and forth a tiny bit on the shaft with my hand. Is this normal? I've owned a lot of bikes and never saw this before. I looked over everything and about the only thing I can think of is that the retaining plate with two 10mm screws in it is possibly to thin? I know I'm grasping at straws here, but I've searched everywhere and can't come up with the answer. Thanks in advance.
I replaced my worn out front sprocket with a new one. I replaced the retaining washer as well.
I have everything tightened down, but I can still wiggle the sprocket back and forth a tiny bit on the shaft with my hand. Is this normal? I've owned a lot of bikes and never saw this before. I looked over everything and about the only thing I can think of is that the retaining plate with two 10mm screws in it is possibly to thin? I know I'm grasping at straws here, but I've searched everywhere and can't come up with the answer. Thanks in advance.
Last edited: