I have just bought a 1981 CB750FZ.
I have just checked the Valve Clearances and they are all to tight
Exhaust 004 004 003 003 003 003 004 003
Intake 003 002 002 003 004 002 004 003
Just asking where about does the high part of the Cam Lobe point to get the correct reading ???
I noticed if I pointed the high part straight up to the sky , it would read say 003
But
if I rotated the Cam Lobe a bit more to be pointing more at the Gasket level, the Gap would then increase and then measure 004
So can someone please tell me where about's Mr Honda says the High Part of the Lode has to be pointing while checking the Valve gap.
thanks, regards Phil
I have just checked the Valve Clearances and they are all to tight
Exhaust 004 004 003 003 003 003 004 003
Intake 003 002 002 003 004 002 004 003
Just asking where about does the high part of the Cam Lobe point to get the correct reading ???
I noticed if I pointed the high part straight up to the sky , it would read say 003
But
if I rotated the Cam Lobe a bit more to be pointing more at the Gasket level, the Gap would then increase and then measure 004
So can someone please tell me where about's Mr Honda says the High Part of the Lode has to be pointing while checking the Valve gap.
thanks, regards Phil