clutch

Hey guys, I have a 1976 cb750 k engine (836 big bore kit) and my clutch has been slipping lately. Also, there was a chatter, almost rhythmic grinding sound coming from my clutch. When I took it apart, I found a crack in my pressure plate. I had that welded and the clutch stopped make the noise...

Anyone know or have seen a torque spec for the four bolts that secure the clutch lifter plate?

Hey guys, so I'm having some issues with my clutch. It's a '76 CB750f. My problem seems to be with the spline washer in the back of the clutch, it's fallen back into the groove behind where the splines end. I'm assuming there's supposed to be something in that groove to hold the washer forward...

Hey guys, so I just rebuilt my clutch and I got it all put back together and now I can't get any resistance in the clutch lever no matter what I do. Any ideas?

Hey folks, I got this little problem here : I want to adjust the clutch pack on my 1980 cb750 (there's too much freeplay on the gearshift selector) but I have to get pass this damn bolt here. I'm not a pro mechanic if you know what I mean, I'm just getting started (its my first bike actually)...

I recent,y purchased a 1970 cb750 bobber and the bike runs nice but the clutch cable is a mess and needs to be replaced. The only issue I have is that the bike has 12 inch apes on it and I do not think that the stock cable will be long enough. If anyone has any ideas it would really help.

Hey Guys, I am new to motorcycle repair and have a limited working knowledge of internal combustion engines. I recently purchased a 1976 CB750F and have been having an issue with it and wanted to get your opinions on the issue and suggestions on resolving it. After I start my bike, and try to...

Hi guys need some help from anyone that would like to give me some info. Well I got my bike out (K5) in the past couple days. Started it up. Let it warm up for a few. Like 10 min or so. Got on the bike went to put it into first gear while holding the clutch and the bike jumped and stalled. The...

I have a 1978 cb750 K8. Will a 1974 clutch drop right in? The whole basket? Thanks

I picked up a 1978 cb750 the other night that runs rough, about to clean the carbs up and see what that does for her. Anyhow I noticed the clutch would not budge. I gave it a pretty ample amount of pressure to see if it would give and then the old cables snapped. What could have it seized up so...

Hey everyone, This is my first post and I'm looking for more information about clutch interchangeability between '75 and '76 sohcs. I have a 76 cb that I am trying to rebuild, but it came without a clutch (except for the outer basket). I have a clutch from a donor '75 motor but the plates...

I am building a cafe out of my '75 CB750F and will be changing the sprockets and chain. Suggestions? Low end vs top end?

Every gear, whether I start at 1500rpm or 6k rpm, it slips around 7k. It will also slip into a neutralish state, like i'm driving a standard tranny car and didn't quite get it in gear....but there isn't a neutral between 3 and 4th gear. :confused: I've changed her oil a couple times, replacing...