Search results

Thank you but neither, im asking about the needle roller bearing not the end float or cush rubber's ,is it normal for the basket to still have some up and down or side to side play after new bearings have been fitted.

Has anyone ever fiitted genuine Honda bearings to the clutch basket and not had any play ? I have fitted these twice and the basket still has play.

I have a 1982 CB900FC and was wondering why the Gas Tank Rubber ( where the bolts down ) has a different part number for this Model compared to the the earlier CB900F's. the part number for mine is . 17613-MB7-670 and the earlier CB900 is 17613-438-000. Is it thicker to lift the Tank to help...

Hi , My other bike is a CB160 and was wondering if someone here could help,, There is No spark at the plug,s when using electric starter although there is at the point's but when using the Kick start it spark's and start's perfectly,, I am guessing an electrical short but where would be the...

I have just rebuilt my CB750F DOHC engine,, reseated the Valves and clearance,, honed the barrels New rings Genuine Honda ,, I have not fitted the Carburettors yet But i have done a ( COLD ) compression test, and i am getting 130 PSI on all cylinders ,, Does anyone think these numbers will...

If the + and - wires on each coil of my CB900f were put on wrong by the previous owner as in + to - and - to + would this damage the Ignition coil's ?? , it ran OK for a short time but now it keep's wetting the plug's on cylinder's 3 and 4 when starting, as soon a i change the Plug's it...

HI Guys, My bike has a good spark on cylinder 1 but very weak spark at cylinder 4 ( same coil ) also cylinder 2 good spark cylinder 3 very weak spark again same coil , i swapped the ht leads round and problem stays the same on 2 and 3 , any ideas

Thank you Niagcool you where spot on.

I have a CB900FC with a Neutral light problem , It works as normal if i put it in gear light go's out but when i pull in the clutch lever when in gear it come's back on any idea's .

Hi Guy's, Is there someone on here that could measure the width of the tail end of the CB750F Chassis on the inside of last two bolt holes ' the bolt holes that hold the rear fender on ' my Chassis may be bent,

Engine pics Only the engine, pics uploaded.

Hi Guys, Could someone tell me what Model this cb750 dohc engine is from by the Engine number, it is RCO2 E 2001873. The first Dohc was RCO1**** and the next CB750F was RCO4*** ( confusion ).

Hi, Has anyone ever tried fitting a CB750 dohc motor into the cb750 sohc frame ? my main question is will fit in the space ? will ex plane why later .

Would any know what the Four O Ring's that fit on the intake side of the Cylinder/Barrel Base are for ? They are refared to by Honda as oil Seal's But the Oil does not travel up the Crankcase stud's to the head , If the base Gasket keep's the Oil in else where why these O Ring's.

I am working on a CB750 DOHC with these Filter Pod's fitted' It is running very poor ' I have inlarged the main's from standard 102's to 115 then 125's it is now running a bit cooler but throttle response is awfull, are pod's a bad idea with CV Carb's ? Has anyone fitted these with good...

Hello from newbe, Can someone tell me if it is possable to fit the standard airbox into this frame CB750K DOHC with the engine already in ???