-
Enter the May CB750 Supply gift certificate giveaway! It's easy... Click here, post something, and you're entered into the drawing!
-
-
millsmobile replied to the thread Front Wheel Bearing & Retainer Wrench.What about the tools to put the new ones back in? Are they needed or can I just use a socket of approximate size? -
I've never had the front wheel off at all on my 1979, about to tackle the front bearing. The manual indicates I need retainer wrench...
-
millsmobile replied to the thread Front sprocket rubber & 630 to 530 chain.Ah yah those look like the right curves. Using an 18 up front is closer to the factory spec, but having the extra pull with the...
-
millsmobile replied to the thread Front sprocket rubber & 630 to 530 chain.7200rpm at 50mph in 5th would suggest a top speed of 69mph at 10k rpms. Have you tested top speed?
-
millsmobile replied to the thread Front sprocket rubber & 630 to 530 chain.Whoa, there's no way that's correct IMO. That's even shorter than what I'm running and I went shorter on the numbers vs stock. At...
-
millsmobile replied to the thread Front sprocket rubber & 630 to 530 chain.Hey Luis, I've kept the rubber one on and have about 1,200 miles on it with no issues. That's the JT339.17RB in front, and JTR284.48...
-
I've got a moderate oil leak coming from the valve cover on the #1 side of the bike. I did replace the gasket, clean surfaces, etc when...
-
millsmobile replied to the thread Intermittent High Voltage.Well it appears the voltage issue was caused by a new alternator failing. I put a new Rick's rotor on it and the voltage is perfect...
-
millsmobile replied to the thread Under Seat Electronics & Heat.Yah I mean it seems like it would be ok, but also the r/r is designed like a heat sink so I figured it was worth asking. There are...
-
I've got an under seat tray in my bike that houses the battery, M-Unit, ignition switch, and starter solenoid. The regulator/rectifier...
-
millsmobile posted the thread Alternator Rotor Failing Due to Crankshaft? in The DOHC Garage (1979-1983).I've got a burnt rotor with less than 600 miles on it. I'm sending it back under warranty and the rep advised me to check the crank and...
-
millsmobile replied to the thread Intermittent High Voltage.Update: stator tested fine, battery tested fine and is taking a charge, however my brand new rotor I put on in August is cooked with...
-
-
Loading…
-
Loading…