Hey all
This is my first post, so I'm hoping i go by the rules on that
Ill start by saying that I'm hoping you all will understand my English, as it is not my first language.
So the question:
I have a 1979 cb750.
I took apart the engine to replace the head gasket.
I haven't measured my valves clearance before i took it apart. So my question is do i need to resemble the engine again, check valves clearance and then replace what ever shims that are not in range? Or can i just replace all the shims by just buying new one in the default size?(if thats even make sense)
P.s
If i can have one more question
How can i measure the timing chain to know if i need to replace it?
Haven't found it in the manual
Thx in advance
This is my first post, so I'm hoping i go by the rules on that
Ill start by saying that I'm hoping you all will understand my English, as it is not my first language.
So the question:
I have a 1979 cb750.
I took apart the engine to replace the head gasket.
I haven't measured my valves clearance before i took it apart. So my question is do i need to resemble the engine again, check valves clearance and then replace what ever shims that are not in range? Or can i just replace all the shims by just buying new one in the default size?(if thats even make sense)
P.s
If i can have one more question
How can i measure the timing chain to know if i need to replace it?
Haven't found it in the manual
Thx in advance