Hi all,
Brand new here.
Putting the cylinder head back on my 96 CB750 Knighthawk engine. I have the manual, but it simply states to "remove nuts in a crisscross pattern" and then the reverse for installation. With older cb's there is a specific sequence for tightening the cylinder head nuts. Does this not apply to the DOHC 750? If anyone has the correct sequence it would be greatly appreciated.
Thanks
Crash
Brand new here.
Putting the cylinder head back on my 96 CB750 Knighthawk engine. I have the manual, but it simply states to "remove nuts in a crisscross pattern" and then the reverse for installation. With older cb's there is a specific sequence for tightening the cylinder head nuts. Does this not apply to the DOHC 750? If anyone has the correct sequence it would be greatly appreciated.
Thanks
Crash