Recent content by shadowmoses42

Called both, and both are reasonable pricing (actually better than my local). Both seemed to know what they were talking about too and had good reviews. Think i'll go with Cycle X as it's physically closer and Ken stated he could have a quick turnaround once I send it to him. Thanks for the...

Really appreciate the help. Any preference you have, one over the other? I'm in PA so I'd have to ship it to either option. APE looks a little more expensive than my local automotive machining shop but if the job is done better I am ok with it.

thanks for the advice! Can you link me to APE engineering or any other ship out cylinder boring services you would recommend?

Thanks for the response! I have a place somewhat near me who was recommended by another mechanic (originally recommended to me and who bores cylinders but typically only cars). I spoke to the guy and he seemed to know what he was talking about, and they specialize in automotive machining. I...

Hi Guys, I'm bring my 1980 CB750C from 62mm to 65mm for the Wiseco 823cc piston kit. I'm curious though, what's the most the stock cylinders can be bored out? Will the cylinders become unstable sooner now because I am widening them each by 3mm? thanks!

Hi Guys (re-posted here instead of Garage) I have a 1980 CB750C I am rebuilding, and while I have the engine open I am curious if it's possible to increase the stroke by using the crankshaft from a cb900f engine. If so, are there any additional parts I would need to make that work? I am boring...

Hi Guys, I have a 1980 CB750C I am rebuilding, and while I have the engine open I am curious if it's possible to increase the stroke by using the crankshaft from a cb900f engine. If so, are there any additional parts I would need to make that work? I am boring the cylinders from 62mm stock to...

Looks like it may be a discontinued part but I was curious if anywhere sells new OEM or compatible aftermarket collars for the front wheel hub. thanks in advance.

Never mind I figured it out. Axle was stuck from being outside for 18 years. Had to ruin it to get it off though.

I'm trying to remove my front hub so i can replace the wheel bearing and powder coat the rims. My manual doesn't go into detail on how to do this and it seems the bolt is very tight. My manual says remove the axle nut and spacer and then remove the axle from the other side along with the...

I spoke to him briefly via email and I planned on using that site. How do the 31s differ from the 29s? Is it a difference of low-end VS high-end? He mentioned that my engine would run cooler and I'd have smoother throttle control, which is great, but do you think the gas mileage will change...

I have a 100% stock 1980 CB750c that I've been working on and off for the past 6 months. The carburetors are seeming to be a lot of work for me and I think I'd rather buy the Keihlin CR29s and straight out replace them. I also like the fact that with these I could eliminate the air box and...

POST!!!!

What's the difference between X and O ring. Do they require tools to attach?

I'm looking for an affordable but still durable chain and sprocket kit for my 1980 CB750c. I believe the specs needed are: 18T front, 43T Rear, 530 and 106 link chain. even if you know a decent sprocket kit and chain separate that's fine. Was just looking for something totally around $200 if...