Recent content by mlbjb16

Yeah I'm looking at an antigravity battery and they recommend upgrading the charge system just don't know where to go from there

Nice work man what kinda swing arm did you use? And where are you located

So I decided to scrap the seat pan in the above pictures used it as a template for the electrics tray I did the full length of the back end Still need trim and weld a little more you can see it on the sides Then I proceeded to start the actual seat pan started with a card board template...

Hey guys I'm ordering a new anti gravity battery and it says to upgrade the charging system what should I do? Should I upgrade To a solid state? Stay with the points? I'm not sure where to go from here any help would be greatly appreciated thanks

When I get home I could send you a pic of my stock one off a 80 c

Forgot to say I trimmed the frame 3.5" to fit the hoop and seat This is trimmed with the seat pan on once I weld the hoop on I will trim the seat pan accordingly

So I decided nothing crazy....funds and a new baby on the way made the decision for me! Lol but I'm doing a low cost cafe racer to flip and build another till I can get my funds right... Here's what I'm thinking the stock cb750c 80 ride height is a little high in the front to get that signature...

Was wondering if anyone had any experience with putting a newer front end on these old cb's I have a 1980 750c and didn't know if there were newer front ends that swap right out any info is helpful... Thanks

Haha no I got it tho thank you. How hard is to replace gaskets on this? Should a I do a full rebuild?

Rebuilding the engine on my bike I have the intake cam out and need help getting exhaust cam chain off sprocket I have clymer manual and have followed each step but I cannot get enough clearance to get the chain off the sprocket...any incite will be greatly appreciated

So I picked up a 80' cb750c a couple weeks ago Started tearing it down completely was thinking about doing a single sided hard tail before I realized the frame is bolted together...I have autocad and solid edge experience so still might try and design a weld on single sided hard tail kit and...