So I decided to scrap the seat pan in the above pictures used it as a template for the electrics tray I did the full length of the back end
Still need trim and weld a little more you can see it on the sides
Then I proceeded to start the actual seat pan started with a card board template...
Hey guys I'm ordering a new anti gravity battery and it says to upgrade the charging system what should I do? Should I upgrade To a solid state? Stay with the points? I'm not sure where to go from here any help would be greatly appreciated thanks
Forgot to say I trimmed the frame 3.5" to fit the hoop and seat
This is trimmed with the seat pan on once I weld the hoop on I will trim the seat pan accordingly
So I decided nothing crazy....funds and a new baby on the way made the decision for me! Lol but I'm doing a low cost cafe racer to flip and build another till I can get my funds right...
Here's what I'm thinking the stock cb750c 80 ride height is a little high in the front to get that signature...
Was wondering if anyone had any experience with putting a newer front end on these old cb's I have a 1980 750c and didn't know if there were newer front ends that swap right out any info is helpful... Thanks
Rebuilding the engine on my bike I have the intake cam out and need help getting exhaust cam chain off sprocket I have clymer manual and have followed each step but I cannot get enough clearance to get the chain off the sprocket...any incite will be greatly appreciated
So I picked up a 80' cb750c a couple weeks ago
Started tearing it down completely was thinking about doing a single sided hard tail before I realized the frame is bolted together...I have autocad and solid edge experience so still might try and design a weld on single sided hard tail kit and...