750kjay
CB750 Member
Hi,
I disassembled and cleaned the carbs on my 750k. I am in the process of re-assemble. I have a plastic washer,spacer, 20mm(.787") diameter, with 2 flats at 16mm(.629") across, a 11mm(.434") center hole and 2 ears sticking up from one side about 1.5mm(.06"). It is approximately 1mm(.039") thick.
I think it came from the right side of no.2 carb where the 2 choke plate rod heads come together and interact with the torsion spring. I can't remember where it goes. I know I said to myself, "I see where this goes, this will be easy to remember". It's been almost a week and naturally I can't remember. The picture I took doesn't show this washer/spacer. The washer/spacer is a little smaller than a nickel.
I am going to add a picture of the washer, after the camera battery charges up.
Thanks in advance,
Jay.
I disassembled and cleaned the carbs on my 750k. I am in the process of re-assemble. I have a plastic washer,spacer, 20mm(.787") diameter, with 2 flats at 16mm(.629") across, a 11mm(.434") center hole and 2 ears sticking up from one side about 1.5mm(.06"). It is approximately 1mm(.039") thick.
I think it came from the right side of no.2 carb where the 2 choke plate rod heads come together and interact with the torsion spring. I can't remember where it goes. I know I said to myself, "I see where this goes, this will be easy to remember". It's been almost a week and naturally I can't remember. The picture I took doesn't show this washer/spacer. The washer/spacer is a little smaller than a nickel.
I am going to add a picture of the washer, after the camera battery charges up.
Thanks in advance,
Jay.