Twobond

Help on the Cam Chain ‘79 750K As I rotate with 17mm wrench the front cam chain will get tight then loose then tight. I have tightened...

Yes, most bolts on my bike, I like to replace with quality graded bolts. Some has heat stress and are brittle. Walter

I use a feller gauge to bench sync the carbs. Just used the vacuum gauges once. With the feeler gauge all was set greate. With the pilot...

One other. The cam chain which runs straight is the tight one. The cam chain which runs vertical is the one which is tight loose tight...

Ok, So on the cam chain, there are two. The front one towards the front tire is tight. The back one towards the rear tire. loose the...

Thank you, I will check my valves now and put valve cover back on. I have a ‘79 and an ‘81. So, I work on one and ride one. Walter

Ok, got a small hole on the side of a ‘79 750K, Took the Vance covers off and both cam chains are loose. Unscrews the bolts and...

Thank you, Walter H-Town

Ok found the oil leak, not a bolt but a crack. See picture….so, what ya’ll JB Weld or gasket sealer high temp. What will adhere to...

1981 with Honda Jammer and 1979 with Vetta Jammer. On the left is the new 4 into four pipes for her, on right is the before pic Walter Texas

I found my four into four pipes for my 1979 750K on EBay. They were not there for months and one day they showed up. Try “Hot Wheels”...

I’m going to take some high temp gasket maker and bead around the area. If it does not stop it, it just might slow it down as a...

The bolt was loose. Tighten with 10mm. Still had oil around it. Should I take off valve cover and tighten head gasket bolts or tighten...

Hello all, I have a USA ‘79. Rebuilt carbs, put on stock 4 into four pipes. I have an oil leak, not in the standard place. See pictures...