bretgs

final update: my sync screws are acting a bit weird so i threw it all out of sync. pulled the carbs to bench sync first, and discovered...

aight, choke was completely dinked. had the levers in the wrong spots. pull out clutch halfway, fires up after about half a second...

update: choke is not working. no working choke and behaving pretty similar to your bike when not using choke certainly seems like...

i seem to remember the choke being weird, actually. I bought a new cable (all the cables are new...cables are cheap), but if i clamp it...

it's been a few months now, but i broke them all down and followed ... some PDF i found on a forum that everyone said was the keihin...

got a similar result i'm afraid. I got cocky and upped the idle screw ("look, it's great now! maybe i just need to set the idle where i...

mm! i'm hoping to get it running "ok" and then revisit the shims. even brand new ones kept coming in a little thinner than expected so i...

luckily for me i can't keep anything straight without a spreadsheet. not that it matters much but 4.1 is cyl 4, towards the stator. 4.1...

they look pretty sync'd to me, but i fine tuned them a bit. it's running nicely now as it's warm so i'll have to wait for another cold...

the choke actuates properly but has minimal impact on these problems. so...i think that's probably a no? lemme give her a carb sync...

hey all, I've had my 81 750c for about five years now, and it's always been a bit of a pain. my friends and coworkers say i need a...

count me in :)