baldjeff
CB750 Member
Hi guys, I just tried to hone my cylinders but I wasn't getting 45 degree cross hatching so I stopped. It looks flatter, closer to 120 degrees. Why is that? Am I not moving the hone in and out fast enough? Or is the drill spinning too fast?
Before: https://drive.google.com/file/d/1EwfP9eeb39NBvbC1PqlfLJFzCJvU__qs/view?usp=sharing
After: https://drive.google.com/file/d/1qF2nAdhbANX6bx-3zBeLi9zyQc5C-qrE/view?usp=sharing
Close up: https://drive.google.com/file/d/1bGUyV4NytL-7H-AIl8eR5mXTJwxAaHKk/view?usp=sharing
Is this close enough just for the rings to seat? Is it possible to fix? Thanks.
Before: https://drive.google.com/file/d/1EwfP9eeb39NBvbC1PqlfLJFzCJvU__qs/view?usp=sharing
After: https://drive.google.com/file/d/1qF2nAdhbANX6bx-3zBeLi9zyQc5C-qrE/view?usp=sharing
Close up: https://drive.google.com/file/d/1bGUyV4NytL-7H-AIl8eR5mXTJwxAaHKk/view?usp=sharing
Is this close enough just for the rings to seat? Is it possible to fix? Thanks.