Wez_
CB750 Addict
Well I have a set of OEM used insulator boots, the ones that install between the intake ports and the carburetors. The number two boot doesn't seem to install onto the intake ports all the way when the other boots are fully seated. It just seems too short or the geometry is wrong. Any tips? The softer rubber boots that install in the air box are a PIA to get that groove seated 360 degrees around them on the air box housing...And there is like only 1 cm of free room to do this all...
So I ordered a new set of insulators.........AND......
PODS!!!.....NOOOOOO!!!!!
I really just want to get the engine verified and running. It will get stripped back down for paint if it runs and idles OK. I just need to figure out how to install all the OEM plastic and rubber. Pods only ran me $22 but ultimately, I want to get the stock air box working....if possibly
So I ordered a new set of insulators.........AND......
PODS!!!.....NOOOOOO!!!!!
I really just want to get the engine verified and running. It will get stripped back down for paint if it runs and idles OK. I just need to figure out how to install all the OEM plastic and rubber. Pods only ran me $22 but ultimately, I want to get the stock air box working....if possibly
Last edited: