The Sea Raven
CB750 New member
Hi all,
My first post, unfortunately is a question rather than an answer. The short of it is - can anyone tell me the fuel measurement on a 1981 CB750K?
To be clear its not the float height I am after, I know this is 15.5mm, its the amount of fuel this will set i.e. would this be on the joint line of the carburettor body, 5mm below, 10mm below etc,
There is a long winded reason for why I am asking this but for the moment, I wont complicate the issue. I have research all over the place but cannot find this and despite my best efforts, and being confident the float height is set as good as I can, there appears to be a wide discrepancy in the amount of fuel in the bowls between two and the other two.
The overflow is about 6-7 mm above the joint line, so that would suggest the amount of fuel should be quite high but ???
Thanks
My first post, unfortunately is a question rather than an answer. The short of it is - can anyone tell me the fuel measurement on a 1981 CB750K?
To be clear its not the float height I am after, I know this is 15.5mm, its the amount of fuel this will set i.e. would this be on the joint line of the carburettor body, 5mm below, 10mm below etc,
There is a long winded reason for why I am asking this but for the moment, I wont complicate the issue. I have research all over the place but cannot find this and despite my best efforts, and being confident the float height is set as good as I can, there appears to be a wide discrepancy in the amount of fuel in the bowls between two and the other two.
The overflow is about 6-7 mm above the joint line, so that would suggest the amount of fuel should be quite high but ???
Thanks