Search results

Love driving my 76 Super Sport

I may have to find a local upholstery shop. I am currently not real happy with the matching up of the two contours between the end of the seat and the beginning of the storage compartment. I have finished painting the hinge and lock and will mount the seat on the frame to start seeing what...

I can't get the Versa Nut USA distributor to answer their phone so I tried the Fastenal store near me. They don't carry the product and don't have anything like it. Thinking about a nylon washer as a backing plate and a nylon nut epoxied to it and then expoxying the washer to the seat bottom...

Thanks madmtnmotors. I need to find a local supplier next to verify sizes need.

I am almost complete done with my rebuilding of a 1976 Cb 750 Super Sport. Last time it was licensed was 1990. Stored in a damp basement until I rescued it in 2015. I only have body parts to finish and a little electrical work. The original seat was covered in cat claw holes and the seat...

Let's see if this picture works. Sorry, don't know why the picture has turned 90 degrees. The wire is coated in a protective sleeve.

I have a little ground wire coming out of the alternator that I need to figure out where to ground it. The wire has a very small circular ground clip at the end but I don't know where on my bike that I have that small of a threaded stud. Any help would be appreciated.

Thanks for your help amc49. I have verified that all m/c parts have been assembled in the correct order however I still cannot get fluid to move past the m/c into the brake fluid lines. They are all new lines and I removed the front m/c from the first banjo bolt and blew air from the caliper...

The inner bore was very clean. I am going to back off the adjusting screw to make sure the compensation port is open. I am having the same issue with the front brakes. I've completely rebuilt the front from master cylinder, new hoses, to brake caliper. It seems that I can't get the fluid...

I found a youtube video showing the proper instillation exactly the way amc49 describes in his post. I done the assembly, everything is connected and I have filled up the cup with dot3. As I do the procedure of bleeding the brakes I am not getting any travel of fluid from the cup. I believe...

I am in the process of rebuilding a 76 CB750F Super Sport. I ordered and received a GL1000 master cylinder rebuild kit, have adjusted the length of the adjusting bolt but I am not certain about the order in which to insert the tapered spring and rubber/metal bushings, for the lack of a better...