Search results

looking for help posting my pics, any advice on file types, file size limits, ........ tried before without any success. just need some help to get me pointed in the right direction, thanks:cool:

Is the oil seal behind the rotor coil serviceable without removing the motor and splitting the case? And is a minor oil leak/drip in this area detrimental to the coil, stater, or brushes? Any info or advice is appreciated. I just finishing up installing a new rotor, and stater coil, don't want...

I am trying to work out some issues with my electrical system. I downloaded a manual from this site but the full schematic at the end of the electrical section is not legible. you can see the lines good enough, but you cant read any of the text. so you cant see any connector names, or wire...

what is the "starter clutch diode/rectifier", and where is it located thanks for the help

1980 cb750k, where is the silicone rectifier located? is this part of the voltage regulator or a separate component? manual page 16-2, speaks of it as if its a separate component.

rotor coil on 1980 cb750k: left or right hand thread on rotor bolt?

Discovered today that my battery is not charging, I have a manual, and haven't started going thru the list yet, was wondering if anybody had any advice on what to start with first? I was thinking maybe the brushes on the stater coil? thanks for any advice

I am now getting ready to do the throttle drop procedure on my 1980 k model. Cant get a steady idle. Using the idle adjusting screw I can get it down to a fairly low rpm, and I think "that doesn't sound to bad" and then in about a min. or two, it starts surging up to over 3-4 k rpm. I adjust the...

Well I finally got my air-box boots, any advice on installation is appreciated. My main question is do I attach them to the carbs first and then to the air-box, or vice-versa? Thanks for the help Leonard

looking for a good reasonably priced pilot screw adjusting tool, any suggestions/advice?

Getting ready to ditch the pods, and go back to the OEM airbox. I will be going thru the carbs again, want to double check a few things. When I rebuilt them the first time, the O-rings for the fuel cut offs were the wrong size, diameter was ok but the cross sectional thickness was thinner...

Replaced the brake shoes on my rear drum as part of rear wheel service, (all new bearings to) all went together fine. This is on a bike I have been restoring for the last 2 months. Finally took it out for a short ride, motor still needs some tuning but all in all it ran pretty good. Had to...