Search results

This is my first go at an engine rebuild and Im torn on if I should replace both rod and main bearings. Engine had 36k miles with low compression on all cylinders. I believe these are the original bearings as they still have their green and brown markings on them and I haven't seen too much to...

Various parts in the link below. Message me if interested. https://drive.google.com/drive/folders/1KdihnbkmJjjbqIXFZI66rVX-JJ2QzWZ4?usp=sharing

My are severely cracked and beaten up. Looking to replace before rebuilding. Thank you.

Hello, I have a 1982 cb750SC DOHC torn down. I'm inspecting major components before reassembly. I was curious if there is a validation / inspection for the primary chain length like there is for the cam chains? My primary drive train tensioner has some tearing to it on the outer most left side...

Getting ready to put the engine of an 82 SC back together and I want to bring the head surface to a good finish. There is for sure some surface rust from the original gasket left over onto the aluminum. what would be the best way to get this cleaned up nice? I plan on using gaskets from here...

Hey Guys! My good friend and I are taking on the DOHC CB750 build. Our plan is a full rebuild, restoration, cafe to the nth degree of detail. We don't know a lot but are learning a ton as we go. If you would like to follow along and help us out our channel is below. We are much further than our...

Hey Guys, New to the 750 build but learning a lot. To keep things short I have a 1982 CB750SC. It had 36,000 miles on it and never saw it run before tearing it down. Compression in cylinder 1,2,3,4 = 75,75,80,60. Adding a small amount of oil raised each by about 5psi. Water testing the heads...