OK dirtdigger, this is what I have;
Piston OD: 2.535"
Top grove: .060" or 1.529mm
Mid grove: .059" or 1.478mm
Oil Ring: .099 or 2.52mm
The actual rings themselves:
Top & Mid: .058"
Oil ring: .195"
I got these measurements with a feeler gunge & a micrometer. The measurements are...
Thanks dirtdigger & tommycarl for your responses - very helpful.
I must have spent a couple hours on cycle x web site - amazing what they have done w/1970s technology.
Once I came back down I realized that I have limited funds available to build those type of bikes(super cool).
I have a...
Hmmm, that's not the answer I was looking for dirtdigger. I'm sure it's the right one though.
How about this;
I have the good head w/the sleeves that need to be over-sized & I have some 836 pistons, can Cycle X fit my 836 pistons & supply new rings for the over-sized bores?
If...
Hey All, I'm new here as well as the CB Honda platform.
I have 2 cylinder heads: 1 w/broken fins w/good cylinder sleeves & 1 w/good fins w/bad cylinder sleeves (need to be bored).
How do I remove the sleeves from these heads?
I already tried tapping(beating) them out & then tried pressing...