DCMojoJim
CB750 New member
Have an Winter project bike , No history on it and been sitting outside for a few years.
Everything on the Bike was well gummed up , rebuilt hydraulics on brakes , battery voltage regulator,cleaned tank etc.etc.
Bought a carb rebuild kit on ebay (chinese). I know cheap crap, but bikes rough and not sure if worth dropping $ into it .
1st thing is the slow jet received is the shorter Keihnin 35jet 23.5 mm long and a 35jet 28mm long came with bike.
Will it draw fuel ? even though it is higher in float bowl ?
The main jets themselves are taller on rebuild kit and the cross holes in the piece it attaches to are a smaller diameter .
The needle ? Forget about it ! It won't even fit , Can't install , it has a extra thick piece at the top and won't sit and can't lock into place.
Boiling old parts might be my only option at this point
Everything on the Bike was well gummed up , rebuilt hydraulics on brakes , battery voltage regulator,cleaned tank etc.etc.
Bought a carb rebuild kit on ebay (chinese). I know cheap crap, but bikes rough and not sure if worth dropping $ into it .
1st thing is the slow jet received is the shorter Keihnin 35jet 23.5 mm long and a 35jet 28mm long came with bike.
Will it draw fuel ? even though it is higher in float bowl ?
The main jets themselves are taller on rebuild kit and the cross holes in the piece it attaches to are a smaller diameter .
The needle ? Forget about it ! It won't even fit , Can't install , it has a extra thick piece at the top and won't sit and can't lock into place.
Boiling old parts might be my only option at this point