PRIMEWORKS
CB750 Enthusiast
So I have a bolt on the exhaust side of my engine just in the front that appears to add some clapping pressure to the gasket between the cylinder and the bottom casing of the engine. My only problem is that I can't get this bolt to tighten therefore I've got a rather decent oil leaking going on because of the lack of any clapping pressure being put on the gasket. Basically, whats happening is I can spin the 10 mm nut that is on the bolt but it never tightens at all...
Has anyone ever had this problem?
Here is a picture of the bolt I'm referring to:
http://http://www.cb750.com/attachment.php?attachmentid=7237&d=1485906439
*picture is not mine but this is the exact bolt I'm referring to. Any help would be greatly appreciated!
Has anyone ever had this problem?
Here is a picture of the bolt I'm referring to:
http://http://www.cb750.com/attachment.php?attachmentid=7237&d=1485906439
*picture is not mine but this is the exact bolt I'm referring to. Any help would be greatly appreciated!