Rusty_Gold
CB750 Member
So I ordered a complete gasket set and last night I tore open my motor because I had what seemed to be an oil leak between the two middle cylinders. Ive done some research and I'm assuming the leak is being caused by the black rubber pucks, if anyone else has any other ideas feel free to inform me.
In a couple days I plan on going back and placing the gaskets, o-rings, etc and putting it all back together so I'm just wondering some tips or tricks about going about it such as using and gasket sealer, or copper spray, I've seen posts that say to use either or, or even neither so just wondering what anyone has to say on that.
I added pictures of the engine when i found the leak and currently taken apart, if you notice anything that should be addressed in the pictures let me know.
Thanks all!
In a couple days I plan on going back and placing the gaskets, o-rings, etc and putting it all back together so I'm just wondering some tips or tricks about going about it such as using and gasket sealer, or copper spray, I've seen posts that say to use either or, or even neither so just wondering what anyone has to say on that.
I added pictures of the engine when i found the leak and currently taken apart, if you notice anything that should be addressed in the pictures let me know.
Thanks all!