Search results

I put an inline filter in the line but the bike died after riding around the corner. After I removed the filter, it ran fine. I think because the filter was made in the far east where filters look like filters and feel like them and cost the same and probably actually do filter but . . . . . too...

I would call this a tachometer drive housing bolt. Have a look at "cmsnl.com" Take some time and I'm sure you will find this exact bolt on this web site. It has expandable parts diagrams. Could be an M5X25 (?) (I don't know the year of your bike.

Yes you can, I own a 1979 CB750K, at present and did own a 1980 F for some years. If you use a 1/4 ratchet with short extention and philips bit, you can undo the (3) screws to each of the float bowls. More room is obtained by removong the starter cover. Pay particular attention to the second...

Maybe just a repeat of something already posted but I found a pretty good way to clean out the gas tank on a well maintained machine. If the tank has been left for a long time and looks pretty bad inside, I can't help you. On a good machine put a little gas in or leave what fuel is in it already...

I bought one last spring. Believe it or not, the jets and float bowls can be nicely cleaned without removing the carburetors. As soon as you remove the carbs, unless you know what you are doing, you are looking at more problems. The more you take them apart and DON'T know what you are doing, the...

Sounds like a spring holding the roller has weakened or broken. The left engine cover must be removed and you will find your issue there.