Search results

Thank you@!!

I have a 1980 cb750c. Im trying to finish my engine build but I'm stuck putting the A-L cam holders on because Im missing one of the dowel pins that insert into the shaft and holder. But i have one extra long one for some reason. The short ones are 8x20 that Is the majority of them and this...

Thank you

1980 Cb750c So Im stil new to doing my own wrenching and have just learned about doing valve clearence checks of course after i replaced my cylinders, jugs, rings etc.. noob move. Most ports are all pretty out of whack mostly tight so my crank shaft is pretty hard to rotate. So ive done my...

I believe im having compression issues, this probably sounds dumb but at the time when i was installing the cylinder jug i lost the two little cylinder shaped circle pieces that conjoin the cylinder jugs to the base. So i made make shift ones out of some piping. Of course i found them after i...

Attempted one of compression tester on cylinder 1 and seems to only get 75 that sounds really bad

Which valves? The exhaust and intake I'm assuming? and i have two compression testers but never seemed to get them to give me any readings. Most likely just improperly using them. Do i need 4 of them?

1980 Cb750C Coming on here because I'm just about out of options on what else to try. My bike runs totally fine once its up to operating temp. The thing screams. No backfiring it's perfect really. Just can't seem to get it to start without full throttle and holding it there for a few...