Search results

My bike needs work!

My CB needs some work.

I've got a 1976 k-6 CB750 project bike to finish!

Finally starting back up on my project bike again after too much time away from a garage focused on school and house renovations.

Turkey Lurkey!

Rebuilding my entire bike this winter so you know I'll need some parts.

If there is a book on the subject, I'm interested. I think you saying that it's more of an experience thing though. I'll look up some spark plug diagrams. I'm know some basics to adjusting oil/fuel ratio on a two stroke but I'm sure it differs when diagnosing AFR.'m Just curious, how difficult...

Got it thanks! And this is pretty much based off of if its running rich or lean at idle and medium-high load right? If you have any suggestions for literature on this subject send it my way.

I apologize as I'm sure this has been asked before but I was unable to find it with the search bar. I have my carbs pulled apart (along with the rest of my bike) and want to put the correct sized jets in while it's easy. Any ideas on what jet sizes I should use? I have independent pod filters...

Small Update. I went through and cleaned all the carb parts and just have to spray out the carb bodies with cleaner before putting them back together. Frame is mostly stripped, just gonna go over it with a flap disk and clean up the small stuff. Shown in the picture is one of the carbs. It was...

Does any one have a carb rebuild kit they would recommend. It's for my 1976 CB750-K.

After 3 years, I'm back to working on the bike. Got busy with school and traveling. Now I'm graduated and quarantine has bought me some extra time. A little update as to where the bike is at: I boiled the carbs and cleaned em out with carb cleaner. Also used a dremel to polish the float...

Pulled of the swingarm and pulled the engine from the frame. Next step is cutting any tabs that I will not be using. Then Paint prep Paint prep will include: Sanding frame removing chipping paint from engine taping bolt holes off Going to paint the frame, suspension, and motor black. After...

Double posted

Im making a wiring harness. This might be a dumb question but everywhere I read they say the wire from the coils go to the "points" and to the battery. What are the "points"

Just the engine and swing arm are left on the bike. One of these days I'll pull the engine and start cutting tabs and prepping for paint. Black Paint Im debating on how to paint the engine. As of now Im going just paint it all black with some satin engine enamel. I have most of the components...

Got the wiring harness out. Decided I'm just going to make a new one. In the process of making a schematic for it at the moment. Ordering a new rectifier/regulator from ricksmotorsportelectrics. and a new starter solenoid. I'll post my new wiring diagram when its done. While I was taking the...

Thanks for the advise dirtdigger! This forum is already proving to be helpful. Looks like I'll be leaving the starter in the bike.

First Day of Work I figured I'd start with the part I dread the most... wiring. Took off handlebars, light, RPM meter, and custom battery box in order to free up wires and take off the wiring harness. So I already hate the guy who put work into this bike. All the wires have been triple wrapped...

Hey all, This thread is going to show my project from start to finish. Bought a 1976 CB750 k6 for 400$. Kinda a weird deal but if it goes bad i can part it out and make most back. The guy i bought it from never touched it, just bought it from someone, put it in his garage for a year, then...