Search results

Does anyone have experience installing these bags on a CB750? I was able to attach it to the two bolts that go through the rear turn signals and grab rail just fine. It's the bottom support bracket that's the issue. The plan was to attach the bracket using the bolt that hold the exhaust and...

I've lost two of the nuts that's on top of the carbs for adjustments. I've looked at many hardware stores, but they are all too small. I know its thread size is M4. Are there any suitable alternatives? That one nut doesn't seem to have a part number on its own.

Any recommended saddlebags that look like it would match the ear of these bikes? I don't need anything too fancy or expensive.

My clutch(cb750k5) is basically useless. I'm able to shift up and down without using it. I understand that shifting up isn't a big deal, but downshifting is. I can also go through the gears when the bike is off. I adjusted the clutch just like the manual says. I also have a new clutch cable...

I get my carbs within 2 cmhg of each other which I believe is close enough. The bike idles between 1000 and 1200 rpm. The bike is able to stop and start easily while the bike is warm. Once the engine cools I have trouble starting the bike without increasing the turns in the idle adjustment...

The previous owner installed Dyna S ignition in my bike. I cant find out where to connect the clip for the test light so I can set the timing. The instructions said to connect it to the blue wire, but I don't see any expose wire like the points would have. Any help to point me in the right...

If the muffler have a crack in them on the outside does that mean the inside is damaged too? I want to get the crack patched up. It's not in a very noticeable location so it will do until I can get a hold of a new one. Can chrome even be welded?

My baby finally arrived after two weeks of traveling across the country. Now that she is here I will start my checks before riding on the road. I plan to keep it in original condition. I alrrady found some things that need to be taken care of. Crackes muffler, turn signals don't work as...

Greetings, I got the Harbor Freight motorcycle lift table and it isn't too bad. The only thing I don't like is the tire clamp. I wanted to replace it with the wheel chock also from Harbor Freight for $65. Of course the holes don't line up and new ones would have to be drilled. Right now I'm...