Search results

need Real nice condition stock rear wheel

On my 1971 K1 my brain is getting fuzzy.....my bike will try to start if I hit starter button when it’s in gear can’t recall if this is normal for a K1? Lurched and Jumped ahead on me today when I stopped and restarted and I almost tipped over I dont have a clutch switch @ lever but as I recall...

Looking for a real nice 18 “rear wheel w or wo sprocket

Upper left #1 cylinder HM300 for my K1 must be HM300 and not rusty or dinged badly just decent to match the 3 others all other pipes are pretty good but small rust hole opposite baffle hole Ican’t stop looking at it ! It sticks out like pipe with a hole in it!!!! can it be patched in any way...

My 1976 K 6 charging would work perfectly until 13 or 14 miles of driving then voltage would drop off to about 11 volts and battery would slowly go down and I'd head for home ,cool down and test everything all components tested to spec???rigged up voltmeter to my tank bag and duplicated issue...

My 1976 K6 is very hard to put on the center stand and it seems to go back over center too far I have other Hondas and Yamaha's that go up onto the stand much easier and down as well it seems this is though the center stand goes back over center to far although the rear wheel does come off the...

Have been out twice and battery starts to go dead tested output and got 13-16 volts after first time and cleaned and checked all electrical plugs ,battery is new and gives 10.5 cranking volts just hooked up my multimeter and went for a ride Cold start have seen 13-15 volts output but ride until...

Have 1034 bulbs in front 1073s in rear,battery is new charging system working fine,at speed ,at idle,at key on only flasher rate always the same ,very slow not really useful,buzzer hooked up also,or not connected no matter At flasher unit no power to either wire with flash going on can even...

Today while replacing my slipping clutch I discovered The Friction disc that has groove rather than block pattern that was for clutch rattle issues on K6 model completely disintegrated and left me with 5 friction discs and one extra steel plate I initially thought and this outside friction disc...

Just got 1976 CB 750 and going thru it found lots of goop in oil tank so dropped the pan too and found fair amount of black flat looks like pieces of gasket materials not cam chain roller type bits all flat pieces ???any ideas no metal at all thou glad about that!

Any condition Thanx for responding