Recent content by Nhmartin16

Trying to post a picture but can’t figure it out. Anyway my exhaust header is in contact with the engine block but the spikes ring thing that gets bolted around the collar to hold the exhaust against the engine has about a centimeter gap between it and the engine bc of the split collars. I put...

This doesn’t seem right. Can’t find the exact answer I’m looking for.

Problem fixed. Took apart the fuse box to find the previous owner installed a cartridge fuse and hid it under the little fuse panel.

Any recommendations on troubleshooting before I go crazy and unwrap the wiring harness?

I didn’t change anything about the running lights I just wanted to make sure it was clear that was going on. I

Currently rebuilding a 1982 CB750 I was putting led handlebar lights on. Got the first side on went to try it and the original signal flashed when selected (worked perfectly) then I switched to the new signal and got a steady light. I was confused (not knowing the LEDs didn’t provide enough load...