Ya your right. My xs650 has mechanical tach also but I hooked a electronic on to it. I looked and looked for the tachs feed wire. jeeeze I sure am dumb sometimes.
I cant seem to find a wire to the tachometer only to the tachometer lights. I realize that the tach may read only half or may read twice as much as it should but it will be something to go by. Besides the after market gauge I have put on this bike has both volt and tachometer in it. thanks for...
Looking for info on tachometer hooking up.
Im helping someone with there bike.
All original wiring is gone and a basic wiring harness has been made.
We have a after market tachometer and wondering which of the tach wires to hook the tach sensor wire to. Maybe someone has wired up a...
Looking for some pictures of the innards of my lowers. Supposed to be a 69-70 by the picture of my lowers. Ive taken them apart to replace the tubes. My innards do not look like anything ive seen in any books. Does any one have pictures of a 69-72 lower taken apart?
I would see if I could locate a wiring schematic for 1976 cb750. I rewired a guys bike last fall 78 cb750 and just looked up what I needed to on the schematic.
I bought a 79 750k swing arm. At least it was listed as such. Was hoping for a straight swap. No such luck. I must have been sold something other that what it was listed or folks are mistaken about straight swap.
Well the one I ended up with has the same axle size but it is wider over all.We...
I copied this post;
A 79 CB 750 swing arm is a straight swap, and gives about two inches. The 80-83 swing arm can be used buy drilling the mounting holes in the frame out to 5/8 inch, and triming 1/4 inch off each side of the swing arm where it attaches to the frame.
TOOLS
And this;
But that is...
I started another thread and got no responses and I looked at the title and was not what I thought I wrote, so I made a new thread with different title hoping I can squeeze a knowledgeable reply, If someone can delete my earlier post Id appreciate it.
Part of my goal of my build is to lower...
Will a 79 swing arm fit on my 70 frame?
Part of my goal of my build is to lower the total bike. I was reading that a 1979 cb750 swing arm is 2 inches longer than sohc model and is direct fit for the earlier years but no models were given. I have a 1970k frame and would like to know which 1979...