Hi,
I have a closed loop vapor blast system and have been doing business locally, (Las Vegas, NV. USA.) I thought I’d reach out to this CB750 community into and offer a unique service to the members. Send your aluminum parts and I can do vapor blasting that will renew them. I use an anti corrosion in my tank and use a CRC coating spray that will keep them looking good. Any aluminum part will look amazing and I can do ferrous and non-ferrous metal as well. Unlike dry blasting, (sand, aluminum oxide,) vapor blasting will not remove material and does not embed into the material. The process uses very high pressure water & super small glass beads.
Note: Vapor blasting WILL NOT remove grease or paint. So all parts should be clean of paint and grease. Prices vary but I will charge CB750 members a discounted rate of $60 per hour, *Normal rate is $120/hr. Typically, a set of 3 carbs to be cleaned externally is 30-40 minutes tops. To have me clean refurbish carbs internally and vapor blast finish, (using existing jets, no carb kits) will take about 2.0 - 2.5 hours. I can give estimates if you send pictures of parts. Please feel free to ask and questions and contact me via e-mail.
willadler737@yahoo.com
I will do my best to give an accurate estimate and let you know the process. Shipping is paid by the customer both ways. thanks in advance,
William Adler
*Video of process :
I have a closed loop vapor blast system and have been doing business locally, (Las Vegas, NV. USA.) I thought I’d reach out to this CB750 community into and offer a unique service to the members. Send your aluminum parts and I can do vapor blasting that will renew them. I use an anti corrosion in my tank and use a CRC coating spray that will keep them looking good. Any aluminum part will look amazing and I can do ferrous and non-ferrous metal as well. Unlike dry blasting, (sand, aluminum oxide,) vapor blasting will not remove material and does not embed into the material. The process uses very high pressure water & super small glass beads.
Note: Vapor blasting WILL NOT remove grease or paint. So all parts should be clean of paint and grease. Prices vary but I will charge CB750 members a discounted rate of $60 per hour, *Normal rate is $120/hr. Typically, a set of 3 carbs to be cleaned externally is 30-40 minutes tops. To have me clean refurbish carbs internally and vapor blast finish, (using existing jets, no carb kits) will take about 2.0 - 2.5 hours. I can give estimates if you send pictures of parts. Please feel free to ask and questions and contact me via e-mail.
willadler737@yahoo.com
I will do my best to give an accurate estimate and let you know the process. Shipping is paid by the customer both ways. thanks in advance,
William Adler
*Video of process :
Attachments
Last edited:
