Rhino2131
CB750 Member
Has anybody put a springer front end on their bike? Everywhere I have contacted, says their springer will not fit on a Honda…?? I would really like to run a springer on my 1978 cb 750.
Thanks,
Rhino
Thanks,
Rhino
Springer front end
- Thread starter Rhino2131
- Start date
Are they all for Harleys? I think someone makes conversion bearings.
Rhino2131
CB750 Member
Ok, because I was looking and they look very similar to the forks I took out. I will look for bearings. Thank you!
RattyRatbikes
CB750 Member
any luck finding bearings to run the harley stem? also im thinking it may be a good idea to start making weld in stems to fit hondas. hmmm
I googled it, and nothing immediately came up. I'm surprised.
RattyRatbikes
CB750 Member
has anyone actually had any luck recently getting hold of cycleonemfg? been months since i first tried to contact. sent 4 or 5 emails so far and nothing.
cause it seems noones thought of conversion bearings or anything to help do what seems to be an extremely commonly asked for kit.
drgnrdr750
CB750 Enthusiast
If the stem is the right length and all you need is the bearings I would take measurements of the stem where they mount and do the same for the frame. Then contact a bearing manufacturer. I think you should be able to find something to fit
