Rebuilding a frankenstien 750

formthelines

CB750 New member
Messages
1
Reaction score
0
Points
1
Location
Goldsboro, NC, USA
hello, first post.

not my first bike, not even my first project, but im at a loss and i want to make this work. Im more mechanically gifted than i am electrically, so this is a bit out of my understanding.

Im trying to install all LED lights (headlight, turn signals, brake lights). the bike i purchased had none of them, and doesn't have the original wire harness. the bike also has an added push-start ignition and all of the needed accessories for it to function, which it does.

now on to my question. are there any stand-alone wire bundles that i can purchase that are set-up for LED's? im talking in-line fuses, relays, the whole nine yards, that i can just connect to the battery terminals and then wire to the hand controls?
 

jpdevol

CB750 Enthusiast
Messages
92
Reaction score
78
Points
18
Location
26187
I'm not aware of a bundle as you describe. The LED's don't require anything special - other than perhaps the flasher relay. Reproductions of the original wiring harness and components are available from various suppliers.

One that I have used: https://www.vintagecb750.com/produc...MI5NagiKnG_AIVIxxlCh0WgAcmEAAYASAAEgI5IvD_BwE

There is an outfit in Japan that offers a fuse block and relay kit that will adapt to 750 wiring (I have used those also)
https://easternbeaver.com/Main/Wiring_Kits/Fuseboxes/fuseboxes.html
 
Top