New to riding

[mrtwowheel]

Measured.......The OEM rotor is 5mm thick at the bolt holes, you should compare that to your rotor. If your rotor measures 5mm this is how it goes........The OEM bolts will not work unless you add one 8mm flat washer to each bolt, not enough thread on the OEM bolt. A better fit would be 8mm x 100mm 1.25 flange bolts with 8mm 1.25 flange nuts with locktite. Gotta put my bolt back in my wheel.

 

[recda4th]

This is also the right shim? It's got the right part number apparently. If that's not correct I can get a different one but it's all rusty

 

[mrtwowheel]

Can't be the same part, it only has 4 holes.

 

[recda4th]

Gotcha. Thank you for going through all the trouble. I'll stop by a hardware store. I'm guessing Lowe's is okay. Which one is the proper shim? The one with 4 holes or 5?

 

[mrtwowheel]

Your bolts go through the damping shim, there are 5 bolts. You will not find that shim "used" in good condition, it is made of steel reinforced gasket type material and is only 1mm thick.

 

[recda4th]

Alright, just to clarify then. I should get this one correct?

 

[recda4th]

I think I may have got lucky and found 2 calipers. Are these the correct ones?

 

[mrtwowheel]

Thought you were only doing one, that involved all of the setup for almost a custom brake build. I'll be busy on my own, maybe someone else can come along to answer your questions.

 

[mrtwowheel]

THIS IS SUPPOSED TO BE A FORUM NOT ONE ON ONE. NO WONDER THIS IS A DEAD FORUM.

 

[recda4th]

I am doing one I was just part checking online on eBay to make sure I bought the right parts. I couldn't find both of the caliper brackets to hold. I'll be sure to buy the shim and the flange bolts you were telling me about. Thank you again for your help