New project CB750F1

[Loki]

It's not that hard to fit the wiring in the headlight bucket. Take your time, straighten out the wadded up wires, pair up those that are to be connected (before actually connecting anything), and start to organize the wire pairs around the outer perimeter of the bucket. You need to leave room for the deep connector on the back of the headlight. This approach works much better than just cramming everything into the middle of the bucket and then wondering why the headlight won't fit. I have actually added a couple of relays in the headlight bucket and still have plenty of room.

EZPZ

Yes that was something I had considered but wasn’t sure if it would fit into the bowl and still leave air space so heat from the headlight wouldn’t cause any issues.

Loki

 

[Loki]

Are you looking for front chrome engine crash bars?

I was but I’ve since sourced a set of Chinese ones. If I’d had them before I sent off my chrome I think I would have sent them as well as some of the chrome is a bit flaky already.

Loki

 

[Loki]

Started prepping the tank for the liner so will give a run down once it's done.

Loki

 

[hinksy]

Hey loki , are you still after engine bars ? I was purusing 4 into 1 as you do , and saw these . Pricey though https://4into1.com/chrome-engine-guards-honda-cb750-sohc-1969-1978/