spdr8cr02
CB750 New member
Hi friends
Gary in Phoenix AZ here. I have a 1979 CB750 that I purchased recently. A lot has been done cosmetically and the PO was definitely inside the motor as he had the exhaust cam installed 180 out of phase. I only discovered this when doing a compression check. Maybe a dumb question but I’m assuming this is going to have bent valves now that I cranked it over to check compression.
I’m fairly handy but honestly new to this engine so any help would be greatly appreciated.
Especially if there are any DOHC wizards in the Phoenix area ?
Gary in Phoenix AZ here. I have a 1979 CB750 that I purchased recently. A lot has been done cosmetically and the PO was definitely inside the motor as he had the exhaust cam installed 180 out of phase. I only discovered this when doing a compression check. Maybe a dumb question but I’m assuming this is going to have bent valves now that I cranked it over to check compression.
I’m fairly handy but honestly new to this engine so any help would be greatly appreciated.
Especially if there are any DOHC wizards in the Phoenix area ?