jnelson1954
CB750 Member
Good Evening All:
This is going to be a little weird, but here it goes... I'm stuck here between a rock and a hard place. You see I'm on a ship in the middle of the ocean off the coast of South America. My 1978 750 Honda is home in Georgia. I've just purchased some Wilwood 4 piston Calipers to do a front end dual disk upgrade. I'm designing the bracket that I'll machine out 6061 Aluminum to join the caliper to the left and right front forks. So my problem is I need a measurement and since the bike is not here... well you know the ending. I sent a photo to my wife and asked her to give me the distance between the disk and the mounting bracket on the inside of the fork... well that did not go well. But here in 750 land, one of you guys can walk out to your garage and give me exactly what I need. How about it. See phots and drawings below.
JNel
This is going to be a little weird, but here it goes... I'm stuck here between a rock and a hard place. You see I'm on a ship in the middle of the ocean off the coast of South America. My 1978 750 Honda is home in Georgia. I've just purchased some Wilwood 4 piston Calipers to do a front end dual disk upgrade. I'm designing the bracket that I'll machine out 6061 Aluminum to join the caliper to the left and right front forks. So my problem is I need a measurement and since the bike is not here... well you know the ending. I sent a photo to my wife and asked her to give me the distance between the disk and the mounting bracket on the inside of the fork... well that did not go well. But here in 750 land, one of you guys can walk out to your garage and give me exactly what I need. How about it. See phots and drawings below.
JNel
Last edited: