Chrisraven
CB750 Enthusiast
I am trying to get the master cylinder reservoir off the base. It is the plastic one with the 4 screws to hold it in place. I removed the 4 screws and tried to pull it out. It will rotate quite freely but it refuses to come out. It looks like there is two rubber "O" rings or seals that is holding the throat of the reservoir on.
I would like to rebuild it just because there was a significant pile of crude in the caliper and the hose is plugged solid. The plunger works in the master cylinder but I think there is something in there that is not operating right. It has been sitting for lots of years.
Anyone know if the reservoir just pulls out? Albeit hard I tried a couple of flat scrappers to try some leverage and still not reaction. It flexes up but not releasing from the barrel of the base.
Thanks
I would like to rebuild it just because there was a significant pile of crude in the caliper and the hose is plugged solid. The plunger works in the master cylinder but I think there is something in there that is not operating right. It has been sitting for lots of years.
Anyone know if the reservoir just pulls out? Albeit hard I tried a couple of flat scrappers to try some leverage and still not reaction. It flexes up but not releasing from the barrel of the base.
Thanks