Introduction

[ogrumpyone]

Good morning. Not sure if I'm doing this right but I'm Ron from Idaho and this is my 750 in an Amen Savior frame. This is my first Honda so I have some learning to do. I have a small hot rod shop so I'm familiar with turning wrenches. Looking forward to this forum and getting the 750 really dialed in. Plan on putting some miles on it. Thanks all.

 

[Travis]

Welcome! I dig the girder. Do you need to run a chain tensioner with those Amen Savior frames? How much travel does the axle have up and down?

 

[ogrumpyone]

Thank you. And there is no tensioner on the chain. Not a lot of movement with the springs but anything helps. I've only ridden it up the street. I still have a little more to do before I put some good miles on it.

 

[hinksy]

That must sound amazing ! Welcome to the site

 

[gotorx7]

Very cool

 

[Old_Crow]

Welcome! I dig the girder. Do you need to run a chain tensioner with those Amen Savior frames? How much travel does the axle have up and down?

Travis, my wife had an old Triumph with a Savior rear section. Looked real nice, but no movement to speak of unless both of us were on it. At the same time, I had another Bonneville with a straight hardtail frame and a girder front end, and truthfully both bikes felt about the same when you were solo on them.