I'd like to remove my rear fender and the chrome bar that wraps around the rear of the seat. Unfortunately, this also removes the stock mount points for the brake light and turn signals. Are there any easy mounting options to get them back on? I'm trying to only make reversisble changes, so adding a frame loop isn't a route I want to take.
Brake light and turn signal options 1981 CB750K
- Thread starter PGCB
- Start date
Easy? Depends on your definition of easy. You can buy thin aluminum bar stock at most hardware stores and drill holes in it to make mounting brackets for all kinds of stuff. That's not terribly difficult.
Off-the-shelf bracketing basically doesn't exist though, so it's not that easy.
It might be easiest to adopt aftermarket brake lights and turn signals which might give you better mounting options.
Off-the-shelf bracketing basically doesn't exist though, so it's not that easy.
It might be easiest to adopt aftermarket brake lights and turn signals which might give you better mounting options.
That's exactly what I did. I used the flat stock to mount a cafe taillight as well.