2-Wire LED Turn Signal Wiring

[Piczker08]

Hello,


I was hoping to get some advice in regards to a LED turn signal wiring. I have a 1980 CB750k.

I’ve got some 2-wire LED turn signals wired in currently. They’ve got a red and black cable.

For the left signal The red cable Is connected to the O cable (per below pictures). The O/W cable is connected to the 2 O cables.
Same for right signal but B and B/W cables.

When I move the turn signal switch they light up but do not flash. Im wondering if I have wired this correctly?

I do have an LED flasher relay.

I believe that the O/W cable is a running light so I don’t see why it should be connected like this given that I only have a 2-wire turn signal, but I don’t see how else to do it.

Any advice would be helpful.

Thanks

 

[Ducklife]

Yeah you don't need the O/W connected, pull it out and tape it up. Just need the Orange and ground to run a signal.