Got 2,5 ohms on primary an 12.6k and 14k on secondary without cables/caps. So I am ordering caps without risistors and new cables. I did have reading of 5k ohms on the caps indeed!
I’m guessing those are the originals, so I’ll check that in a couple of hours and maybe order some new ones without Resistor. I’m going to messure the secondary’s of the coil too, without the cables this time. Hope this gives me a reading. Otherwise I am ordering a new one. Best 2 Ohm, 3 or 5...
Thanks for te quick respons!
Well got an electrical ignition and the two points are pretty clean and set them on 0.4mm. On the 2 coils I have 2 Ohms, doesn’t that have to be 5? And between the spark holders I have 21.1k Ohms and on the other ones no reading with the caps on, 23.2k without them...
Hi all! I am still rebuilding my CB750 ‘79 kz DOHC. DNA air pods with 4 in 1 exhaust with open muffler. He runs ok and starts emmediatly (with a bit of choke). But when running I can hear he is skipping some strokes. Now I did the timing with a timing light on the cable of spark plug cyl1. ( the...
Here's red start wire that goes from the M-unit start output (max 30A) to the solenoid to connect the solenoid from battery to starter.
So the main power only can go through the fuse? The 15mm² wire goes to the m unit + and then goes to the solenoid, then to the motor which is grounded.
So the...
Thanks Amc for the quick reply!
Don't know what I am doing wrong with the 40Amp fuse below though..
Followed the M unit instructions considering the fusing.
What do u mean with 'shunts' around the fuse?
I measured around the fuse about 110Amps
Here (pretty) drawing of my 40amp fuse and link...
Hi guys! Pretty new on this forum!
I have a couple of questions regarding the charging system/regulator/LIFEPO4 battery.
- I am currently building a CB750 K(z) 1979 with an M-unit and all LED lights
https://ibb.co/K9nMMqr
I bought a Ultrabatt Multimighty 12200M+ 150CCA and connected this in...
Hi Ryan!
I am new as well on this forum, rebuilding a 79 CB750KZ and removed the carbs for a cleaning but started rebuidling it as well.
This manual helped me a lot: https://boldorclub.nl/wordpress/wp-content/uploads/2015/01/honda_carb_manual_revf.pdf
Just do it step by step, use the proper...