Deep cleaning a set of very dirty PD41A carbs for a '77 CB750 K7 project and found parts not shown in the factory parts fiche anywhere. Throttle shaft opening in the carb body has a sleeve / bushing that fell out after an ultrasonic bath. Carb was so dirty I didn't notice the sleeve or the...
Hi,
Anybody know a source for the rubber bushings inside the headlight / fork ears? Rehabbing a barn find K1/K2. It came to me as a '71 frame & motor with a '72 front end. It sat for quite some time before I got it and most all the rubber bits on it need replacing. There are used bushings...
Rebuilding a set of Keihin 7A carbs and noticed #1 carb - i.e. carb with choke lever - is missing one of those little brass vent disks. Not sure if I did it when blowing out passages with my air compressor or if it was missing all along. It's not the disk in the passage that goes to the air...
Is there any company out there that is making new cylinder jugs in the stock 750cc bore? I thought I found a website where new jugs were being sold as part of a rebuild kit - pistons, etc - in the stock size - but can't seem to find the site again.
Howdy All,
Looking for some help determining who made the 812cc pistons in the attached pictures. I recently acquired a project '71 CB750K1 that's been sitting in a garage for at least a decade. The previous owner took it on as an unfinished project from another dude but for various reasons...