Search results

Hi hinksy Not used JB weld yet, I read somewhere that someone had used it with a .45 caliber shell (slid over the main jet housing) and it seems to have worked. Floats and float valves are all new, I have also checked bowls and overflow tubes for leaks. Thanks for the input bud Shreks

No drama s you're welcome. Yes that's how I have done mine, all four were leaking from the overflows when I first got the bike. Now only 2 with the worst being the one with the cracked jet housing. A bit of a pain, if the carbs are sitting a couple of degrees off, then the float height can be...

Hi Loki, I have ordered brass pipes but so far the outer diameter is too wide to fit between the jet housings. I have attached the resin info for you (not tried it yet due to trying to find the correct pipe) Give me a couple of weeks and I will update you on the results. Hope this helps Shreks

Thanks for the reply hinksy. I have seen these before. I set mine on a slight angle. Looking at your image I will try doing them at the same angle. Thanks again Shreks.

Good evening all. I have recently purchased a Cb750 four k2 there is fuel leaking from the overflow pipes. I have cleaned out the jets, replaced float valves and floats (I noticed no 3 carb main jet housing has a hairline crack down the side). Someone who has probably over tightened the main...

Hi KB, thanks for the information. I have seen these videos and thought the same. Before I started to strip the lift plate I readjusted the the push rod that goes through(the screw that they say, screw in until resistance is felt and back off 1/4 of a turn) My thought process was if it wasn't...

Hi all, looking for some help please. After replacing the clutch cable on my cb750 four k2 after about 5 miles there was a twang noise the clutch lever went loose and the bike stalled. I limped back and on inspection found the clutch actuator arm was stuck forward (in the engaged position) I...