• Enter the March CB750 Supply gift certificate giveaway! It's easy... Click here, post something, and you're entered into the drawing!

Cylinder sleeve puller

loxley007

CB750 Addict
Messages
147
Reaction score
48
Points
28
Location
England
Hi all, I need to pull the sleeves from my 1979 CB750 engine (I need to swap out damaged ones for non damaged ones).

My question is whether any members have a sleeve puller they could lend me? I’m in Nottinghamshire, UK.

My alternative is to fabricate one.

Anyone able to help out?
 
Typically ya don't need a puller at all; heat the assembly to about 200C and the sleeve can be easily pushed out by hand. Tip: placed upright in the oven, the aluminum cylinder will want to slide down the sleeves. Heat again to install new sleeves (sleeves should remain cool) and make a clamp jig to squeeze and hold the sleeves in place as everything cools as they'll want to wiggle out of place
 
Typically ya don't need a puller at all; heat the assembly to about 200C and the sleeve can be easily pushed out by hand. Tip: placed upright in the oven, the aluminum cylinder will want to slide down the sleeves. Heat again to install new sleeves (sleeves should remain cool) and make a clamp jig to squeeze and hold the sleeves in place as everything cools as they'll want to wiggle out of place


Fantastic, thanks for the advice.
 
Back
Top